What are the reasons for the AVENTOS lift system front not closing properly?

It is often the case that the lift system front for the AVENTOS HF does not close properly following adjustment. There are two potential problem situations here:

1) You have adjusted the gaps and then closed the telescopic arm. The front is protruding in the middle.

In this case, it is likely that the telescopic arm has been adjusted too short. To correct this, you must first loosen the telescopic arm again, then press the top front to the cabinet and pull out the bottom front slightly with your other hand. This will lengthen the telescopic arm. Attach both fronts, open them again and then close the telescopic arm.

2) You have adjusted the gaps and then closed the telescopic arm. The bottom front is protruding from the cabinet.

In this case, it is likely that the telescopic arm has been adjusted too long. To correct this, you must first loosen the telescopic arm again, then pull out the top front slightly and press the bottom inwards slightly. This will shorten the telescopic arm. Both fronts will now be protruding in the middle due to the arm being too short. Now press the top front to the cabinet and pull out the bottom front slightly with your other hand to readjust the telescopic arm to the correct length. Attach both fronts, open them again and then close the telescopic arm.

For older AVENTOS HF lift mechanisms, it may be that the front closes unusually quickly at the end of the closing motion. If it is not possible to correct this despite adjustment being carried out correctly, please get in touch with our contact partners in your country, so that we can assist you as swiftly as possible.

To do so, please click here.