SERVO-DRIVE uno

SERVO-DRIVE uno for bottom mount waste bin solutions – quick and easy to install

This picture shows a SERVO-DRIVE unoOpen bottom and top mount waste bin solutions with ease thanks to the SERVO-DRIVE uno. Simply touch the front with your hip, knee or toe to open the waste bin pull-out. We will show you how to easily install the electrical opening support system. Simply find the right position, automatically set the depth and fit with just a few tools – that’s it!

 

 

 

This picture shows SERVO-DRIVE uno in the cabinet   This picture shows SERVO-DRIVE uno as single set

 

Install the pre-assembled individual set in no time at all. Also ideal for retrofitting.

 

Install the SERVO-DRIVE uno quickly and easily.

  1. Fit the Blum distance bumper at half-height on the side of the cabinet
  2. Pull the film from the T-shaped assembly device and position it on the back wall of the cabinet. Make sure the notch on the assembly device is in the middle of the cabinet
  3. Slide the SERVO-DRIVE unit a short way onto the assembly device
  4. Attach the pull-out and close it – the SERVO-DRIVE unit will be automatically pushed into the correct position
  5. Screw the SERVO-DRIVE unit in place and remove the transport protection
  6. Finally, connect the SERVO-DRIVE uno to the outlet

This video shows you how to easily carry out these 6 simple steps:

 

The installation instructions can be found here: LINK

 

 

SERVO-DRIVE uno

6 thoughts on “SERVO-DRIVE uno

  • February 1, 2020 at 23:09
    Permalink

    We see that the problem of this unit opening on its own is worldwide. We have a unit that was installed four years ago and it has always tended to open on its own, but lately it is a constant problem. Any advice you can give us would be much appreciated.

    Regards.

    Bob Harman

    Reply
    • February 3, 2020 at 8:35
      Permalink

      Dear Bob,

      our US customerservice will get in touch with you asap and go through the troubleshooting steps.

      Best regards
      Matthias

      Reply
  • March 11, 2021 at 18:44
    Permalink

    I am also seeing this same problem: the unit is constantly opening on its own or with the slightest vibration in the kitchen. We really some help. Thanks.

    Reply
    • March 12, 2021 at 9:03
      Permalink

      Hi Dave,
      thank you for your message. My colleagues from US will get in touch with you directly to assist you.
      Best regards
      Andrea

      Reply
  • June 24, 2021 at 18:50
    Permalink

    Hi –
    Is there a safe way to clean the rails on my servo drive bottom mount waste bin (from dust, waste particles, etc.? Would the rails need to be taken out do do this?
    Thanks!
    Craig

    Reply
    • June 25, 2021 at 9:14
      Permalink

      Hi Craig,
      thank you for your message. If dust or waste particles do get into the system, remove them with a vaccum cleaner. On our website, there is a Downloads & Videos section for every product where you also can find the cleaning information (see link below).
      LINK
      I hope this helps, otherwise don’t hesitate to get in touch with us again or call your local Blum representative found here: http://www.blum.com/contact
      Best regards from Austria
      Andrea

      Reply

Leave a Reply to Matthias Winkel Cancel reply

Your email address will not be published. Required fields are marked *

*